ProCal

GPIB (IEEE-488) Communication Using ProCal
ProCal supports communication with both reference instruments as well as UUT's via GPIB (IEEE-488) Communication. To use GPIB communication, a supp...
Thu, 17 May, 2018 at 7:52 AM
Supported Multimeters
ProCal includes built-in support for numerous multimeters that are controlled without the need for commands to be written in procedures. This list continues...
Thu, 17 May, 2018 at 7:54 AM
Supported Multiproduct/Multifunction Calibrators
ProCal includes built-in support for numerous multiproduct/multifunction calibrators that are controlled without the need for commands to be written in proc...
Thu, 17 May, 2018 at 7:58 AM
Test Status (Passed, Probable Pass, Probable Fail, Failed)
ProCal offers multiple test statuses to indicate the state of each test. When performing calibrations using individual uncertainties, there are four test st...
Thu, 17 May, 2018 at 8:00 AM
Sending Test Nominal to UUT (Version 6.x)
Starting with Version 6 of ProCal, new commands have been added to send the nominal test value to the UUT. In the Instruments window, lines with the fol...
Thu, 17 May, 2018 at 8:03 AM
Procedures included with ProCal
ProCal comes pre-loaded with over 350 procedures ready to use for modern test equipment The latest procedure listing as of 25th April 2017 can be found...
Thu, 17 May, 2018 at 8:05 AM
ProCal : Cold Junction Mode Selection During a Calibration (EA001A Thermocouple Adapter)
The EA001A Thermocouple Calibration Adapter connects to the 3000A/4000 Range of calibrators and offers either : > Automatic Compensation (using a bui...
Thu, 17 May, 2018 at 8:16 AM
Adding Adapters to ProSet and Printing on Certificates as Traceable Instruments
STEP 1 : Run ProSet Run ProSet and add instruments if needed to allow you to create new items above line 10 To add a new instrument to the traceabil...
Thu, 17 May, 2018 at 8:18 AM